使用注意事项
PT500-540 TTL数字压力变送器使用注意事项
产品供电3.6VDC(范围:3-5VDC);
严禁使用硬物(如:螺丝刀、手指、铁钉等)去使得压芯体受压力测量输出;
电源和信号线按订购产品规格要求,正确接线;
产品安装时,受力部位为“过程连接六方扳手位”,扳手规格与六方相对应;
严禁被测系统的介质温度、压力量程、激励电压超过变送器的额定使用范围;
注意保护变送器引出电缆,现场使用跨度过大时,建议使用金属管保护或架空;
压力变送器属精密计量仪器,切勿强加冲击、摔打,以免损坏芯体;
产品安装于通风、干燥、无强腐蚀环境,露天安装加防护装置,避免阳光直接照射;
Precautions for PT500-540 TTL digital pressure transmitter
Product power supply 3.6vdc (range: 3-5vdc);
It is strictly prohibited to use hard objects (such as screwdriver, finger, iron nail, etc.) to make the pressure core body under pressure measurement output;
The power and signal wires shall be correctly wired according to the specifications of the ordered products;
When the product is installed, the stressed part is "process connection hexagon wrench position", and the wrench specification corresponds to hexagon;
It is strictly prohibited that the medium temperature, pressure range and excitation voltage of the tested system exceed the rated use range of the transmitter;
Pay attention to protect the outgoing cable of the transmitter. When the span is too large on site, it is recommended to use metal pipe for protection or overhead;
The pressure transmitter is a precision measuring instrument, do not impose impact or smash to avoid damaging the core;
The product is installed in a ventilated, dry and non corrosive environment, and installed in the open with protective devices to avoid direct sunlight;